ODK4/MCU
Configuration File Transfer Setup
USB Stick Preparation
Insert your USB flash drive in your computer
Ensure that no other files are on the USB flash drive
Unzip config file it will create folder “odkconfig” with one file inside the folder.
Eject the USB flash drive from the computer
ODK4/MCU Reprogramming
Turn bus power on, wait for the ODK4/MCU to boot up.
Insert the USB Memory Stick into the USB slot on the face of the ODK4/MCU.
-
If only one configuration file is present on the USB Memory Stick, it will automatically transfer to the ODK/MCU memory.
If multiple configuration files are present, you will be prompted to select the file you want to load onto the ODK4/MCU.
If message listing files are also present on the USB Memory Stick, you can select those files to upload also.
NOTE: In some cases, you will need to Install the files using the “INSTL” button. You will then be prompted to remove the USB Memory Stick.
The ODK4/MCU will show the file progress, and reboot.
The ODK4/MCU will now operate with the updated files.
Setting the VehID - The Vehicle ID is used by the ODK4/MCU to identify the vehicle for purposes of diagnostic files and wireless file transfer.
Turn bus power on, wait for the ODK4/MCU to boot up.
Press Menu>ODK(or MCU) > Enter Password 6511
Press Confg>Misc>VehID
Enter the vehicle number using the numeric keypad or the left and right arrows and the Selct key to choose letters. Press the Green Square ENTER key to save.
Pres Cancl multiple times to return to the main screen